The washer will go into a hold and drain routine for 8 minutes.
Maytag 3000 washer locked with door open.
The door may immediately unlock.
The door should unlock after 60 seconds.
After 15 minutes it will reset and the motor will stop humming and the door will unlock.
After plugging the washer in one of the following 3 events will happen.
Door on the maytag 3000 series front load washer will not open after placing clothes in the washer shutting the door and pressing the start button a buzzing sound starts and then an f22 code comes up.
Door on the maytag 3000 series front load washer will not open after placing clothes in the washer shutting the door and pressing the start button a buzzing sound starts and then an f22 code comes up.
Reconnect power to washer plug in.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
The top panel will pull straight back up and off.
The door lock led light will blink.
If not call for service.
This is a page about unlocking the door on a maytag front load washer.
Nothing else will appear to be happening with the machine during this time.
Run a drain and spin cycle.
The door will not immediately unlock while the cycle is running due to a possible high water level in the washer high water temperature tumbling or spinning.
It may take up to five minutes for the washer to stop spinning and draining before the door will unlock.
Remove the screws coming in from the back of the top panel.
The door should unlock after this is complete.
Wait approximately 2 minutes for control to reset.