Maytag French Door Refrigerator Water Filter Not Dispenser Problems

If the door switch fails the dispenser will not turn on.

Maytag french door refrigerator water filter not dispenser problems.

7 possible causes and potential solutions. A clogged or incorrectly installed water filter will reduce the water flow to the ice maker and dispenser which will result in small ice cubes low ice production or decreased water flow. Use a sturdy container to press and hold the water dispenser pad for 5 seconds then release it for 5 seconds. If the control panel is still not responding try resetting the refrigerator as instructed below.

Flushing the system is needed every time the filter is changed or once the refrigerator is installed to the water supply line for the first time. Click here for more information on how to flush the water system. If the refrigerator has a water dispenser check for a problem with the filter by doing the following. Find the most common problems that can cause a maytag refrigerator not to work and the parts instructions to fix them.

The door switch turns off the ice and water dispenser when the refrigerator door is open. Dispense water using the water dispenser and note the amount of water flow. Power unit down by turning off the circuit breaker s or unpluging the product for 5 10 minutes. If the door switch does not have continuity when activated replace it.

The door switch turns off the ice and water dispenser when the refrigerator door is open. Flush the system is needed every time the filter is changed or once the refrigerator is installed to the water supply line for the first time. If the refrigerator has a water dispenser check for a problem with the filter by doing the following. Refrigerator water dispenser not working.

Air in the water system may cause dripping at the dispenser or small hollow ice cubes. If the problem persists schedule service. Reset power to the product. Dispense water with.

Door parts drawer parts drip bowl drip pan parts duct venting parts fastener parts filter parts fuse. Repeat until water begins to flow. The filter is located either in the base grille below the refrigerator compartment door or inside the refrigerator compartment. If the door switch does not have continuity when activated replace it.

To determine if the door switch is defective use a multimeter to test it for continuity. To determine if the door switch is defective use a multimeter to test it for continuity. 1 if your old refrigerator water filter worked and water flowed from the dispenser normally but after installing a new water filter the water is only a trickle from the dispenser try reinstalling the old filter to see if the cause of the issue is the new filter. The air in the water system may cause dripping at the dispenser that is considered a leak or for the water to dispense slowly.

2 you may have bought a cheap aftermarket water filter. Dispense water using the water dispenser and note the.